HI,there anybody can help me on TOSHIBA machine with Tosnuc 800.
How to load and copy use floopy disk. with parameter and what step should follow.

Shasha

What kind of control is on your machine?

Stevo

(The opinions in this post are my own and not those of machinetoolhelp.com and its management)

TOSNUC = Toshiba + Fanuc

Sample pictures of TOSNUC.

Attached Thumbnails

   

IT IS TOSNUC T800. Anybody there have M60 macro program with 6 pallet.
AS i don't have any backup disk.

Sinumeriko,
What model Fanuc? I could not make out the mode on the pictures. It looks maybe like a 10,11,12 or 15 series Fanuc control.

You say you have s floppy drive on it. What model is that? Greco or something of that sort. Do you also have a RS232 port on it?

Stevo

(The opinions in this post are my own and not those of machinetoolhelp.com and its management)

Stevo,

Those are just sample pictures of the TOSNUC brand, not the actual model.

Perhaps Shasha would like to upload here some pictures of his machine/control.

Oops my apologize Sinumeriko I thought you were the one originally asking the question. Yes ShaSha needs to tell us what model fanuc.

Stevo

(The opinions in this post are my own and not those of machinetoolhelp.com and its management)

Hi, Guys
It TOSNUC 800 Controller.

I am not very familiar with that control but will help out if I can.

Is there a model of the floppy drive that you have on the control? It will depend on what it is to determine what manual or data to research. Does your machine have a RS232 port on it?

Stevo

(The opinions in this post are my own and not those of machinetoolhelp.com and its management)