Mastercam 9 to Mori Seiki 35/40 error code 085 whenstoring data in the memory

russarao · #1 (**permalink**) 02-20-2009, 08:14 PM

Hey guys,
does any one know what the problem might be, I just upgraded from Mastercam 8 to Mastercam 9 after a hard drive crash, and when I send a program, it sends out of the PC, but doesnt go into the CNC and I get an error cod #085 Thart says, When storing data in the memory by using RS232C interface, an over-run or framing error was generated.
Any thoughts would really be greatly appreciated. I am down now and waiting.

Thanks,
Russ Arao (818) 709-4781

Petro CNC · #2 (**permalink**) 02-20-2009, 10:22 PM

What are your current communications settings in Mastercam? Also do you know what they are in the machine? Is your baud rate set the same on both and what type of handshake is set in Mastercam?

russarao · #3 (**permalink**) 02-24-2009, 11:07 AM

Thank you so much for responding to my question. You asked me questions about the communications settings on MC9, I played with it then it started sending! Again thank you so much.

Russ Arao

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mori Seiki NL2500 - Must Sell.	platinm	Mori Seiki Lathes & Mills	3	04-23-2010 08:16 AM
Fanuc 6m replace loop data in bubble memory need help	Napigator	Fanuc Controls	1	01-11-2009 08:20 AM
Eror Code 323 Hitchachi Seiki Lathe	Paul	Machine Repair & Troubleshooting	1	10-12-2008 09:33 AM
ERROR CODE HELP!!	cnchelp	Machine Repair & Troubleshooting	3	02-10-2008 03:42 PM
Mori Seiki DL20 G10 code	kgt54	Mori Seiki Lathes & Mills	1	12-16-2006 03:13 PM

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode