| |||||||
| Home | Recent Posts | HELP-FORUMS (ask/answer) | Classifieds-ads | File Sharing / Documents | Photo Galleries | Polls | Newsletter | Machinetoolhelp.com. |
| Machine Repair & Troubleshooting Machine Repair & Troubleshooting forums- Post the problems your machine is having and try to find whats wrong with your CNC. Please use your specific machine category when possible for machine repair troubleshooting. |
 |
| | Bookmark or Share | Thread Tools | Display Modes |
02-07-2008, 10:34 AM
| |||
| |||
 ERROR CODE HELP!!
access violation at address 005BAB85 in module 'WINDMILL.EXE' is what it says it tells me to check that the machine is on and the RS232 cable is connected and they are WHAT IS HAPPENING!!!!!!! :mad:
my cnc machine sucks!  |
|
02-07-2008, 04:23 PM
| ||||
| ||||
|
Judging from the syntax of the error, I'm guessing that you're using a Denford machine? It sounds like it's probably a COM setting error. Cody Stamper (Note: The opinions expressed in this post are my own and are not necessarily those of machinetoolhelp.com and its management) |
|
02-10-2008, 03:42 PM
| ||||
| ||||
|
Check your COM settings. Baud rate, stop bits etc. This error is telling you there is no communications between the PC and the machine.
Cody Stamper (Note: The opinions expressed in this post are my own and are not necessarily those of machinetoolhelp.com and its management) |
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
| |
Linear Mode
